|
| Our anti slip treatments and our anti slip tapes are Certified “High Traction” by the National Floor Safety Institute (NFSI)
|
| Many of our floor care products are UL® Classified for slip resistance
|
|
Super Acrylic Slip Resistant Coating - $99.00 to $89.00 based on quantity & color
  Color Chart 97300 series Before application of No Skidding Super Acrylic 97300 Series After application of No Skidding Super Acrylic 97300 Series Super Acrylic Slip Resistant Coating - Residential Ramp    |
|
Product Options
| Color: |
|
|
NO SKIDDING® SUPER ACRYLIC HIGH PROFILE, SLIP RESISTANT COATING # 97300 Series :
- Tough, abrasive, one part anti-slip coating for a variety of interior and exterior applications.
- Anti slip traction integrated into the coating for ease of application.
- No messy mixing or measuring.
- This product can significantly reduce the chances of slipping.
- It is low odour and low VOC.
- Soap & water cleanup.
- COLORS AVAILABLE: White, Gray, Beige, Yellow, Green, Brown, Red, Black and Handicap Blue.
- Priced by the gallon (3.78 L).
RECOMMENDED USES: Suitable for use on walkways, steps, ramps, locker room floors, boat decks, tennis courts and a variety of other interior and exterior concrete, wood, and metal surfaces that have been properly prepared. This product is not for use in areas where it will be underwater; it is also not for use on garage floors or other areas of wheeled vehicle traffic. Please note that our Clear Super Acrylic can appear whitish when wet and return to clear when dry.
We recommend our 3/8th inch nap roller refill with our one part anti slip coatings. We suggest back-brushing after rolling to help with penetration and uniformity for steps, ramps and similar small areas for best performance and longevity.
SURFACE PREPARATION for application of this product to concrete surfaces:
- Please ensure that there are no structural defects, ponding water, or hydrostatic moisture from below the surface.
- The substrate should be dry and clean, no contamination, dirt, dust, mildew/algae, oil, grease, efflorescence, water repellents, sealers, chemical de-icers, and any other foreign matter.
- New concrete should age at least 30 days.
- The surface should be "open" and porous through acid etching, power washing/blasting, or mechanically abrading so the coating may obtain adhesion.
- All grease, oil, and other stains/contaminates must be removed with a cleaner/degreaser according to instructions.
- This is usually best done by power washing. The surface must be suitable for coating to begin with or else it should be repaired or replaced first.
Note: Smaller areas may be able to be adequately prepared by hand rather than with large equipment but the condition achieved before coating must be just as good.
Label directions should be followed for application and curing.
For more information, please visit this product DATA sheet and
BROCHURE.
|
Item Number: S-P-DO-9528
3/8 inch Nap Roller Cover distributes paint evenly across the surface, creating a professional paint finish on your floor.
|
Item Number: S-P-614
Heavy duty 5 wire cage roller frame with ergonomic handle holds up to any project. The threaded handle can be used with any standard extension pole.
|
Item Number: S-P-ST-9514
Used for high profile coating for fuller textures.
|
Item Number: S-W-R233-18
Made for industrial grade epoxy and urethane coatings.
Reinforced polypropylene core, shed resistant, high density nap.
|
Item Number: S-P-610
For use with 18" rollers for application of all two part coatings.
|
Item Number: S-P-612
For paint applications on large floors areas
|
|
|